These results are ranked by popularity.
Error | |
---|---|
024-989 | Description: Booklet Low Staple R Booklet Stapler Low Staple Rear signal was detected just before Stapling operation. Booklet Stapler Low Staple Rear signal was detected at power On, at initialization, or when the Interlock was closed. |
004-340 | Description: Controller RAM Fail or Flash ROM Limit Fail Engine Control Board (MCU PWB) RAM test failed or limit of Flash ROM or Flash ROM failed. |
012-113 | Description: Booklet In Sensor On Jam The Booklet In Sensor did not turn On within the specified time after Punch Out Sensor ON. |
001-301 | Description: Left Lower Cover (Door B) Open Left Lower Cover (Door B) is open |
008-622 | Description: RegiCon Data Overflow (A1 Patch X) At A1 patch detection, the XSO correction setting value for either Y, M, C, or K exceeds the setting range (NVRAM value 0 to 472). |
The most common error codes.
Error | |
---|---|
024-989 | Description: Booklet Low Staple R Booklet Stapler Low Staple Rear signal was detected just before Stapling operation. Booklet Stapler Low Staple Rear signal was detected at power On, at initialization, or when the Interlock was closed. |
004-340 | Description: Controller RAM Fail or Flash ROM Limit Fail Engine Control Board (MCU PWB) RAM test failed or limit of Flash ROM or Flash ROM failed. |
012-113 | Description: Booklet In Sensor On Jam The Booklet In Sensor did not turn On within the specified time after Punch Out Sensor ON. |
001-301 | Description: Left Lower Cover (Door B) Open Left Lower Cover (Door B) is open |
008-622 | Description: RegiCon Data Overflow (A1 Patch X) At A1 patch detection, the XSO correction setting value for either Y, M, C, or K exceeds the setting range (NVRAM value 0 to 472). |
024-989 | Description: Booklet Low Staple R Booklet Stapler Low Staple Rear signal was detected just before Stapling operation. Booklet Stapler Low Staple Rear signal was detected at power On, at initialization, or when the Interlock was closed. |
004-340 | Description: Controller RAM Fail or Flash ROM Limit Fail Engine Control Board (MCU PWB) RAM test failed or limit of Flash ROM or Flash ROM failed. |
012-113 | Description: Booklet In Sensor On Jam The Booklet In Sensor did not turn On within the specified time after Punch Out Sensor ON. |
001-301 | Description: Left Lower Cover (Door B) Open Left Lower Cover (Door B) is open |
008-622 | Description: RegiCon Data Overflow (A1 Patch X) At A1 patch detection, the XSO correction setting value for either Y, M, C, or K exceeds the setting range (NVRAM value 0 to 472). |