Select an Error Code or Type an Error Code to begin searching
Error
Xerox WorkCentre 5765 Top Searches
These results are ranked by popularity.
Error
10-132, 10-133, 10-134
Description: Lead Edge Late to Inverter Sensor RAP (65-90 ppm) 10-132 The lead edge of the paper failed to actuate the inverter sensor within the correct time after the fuser exit switch is made, for a simplex sheet. 10-133 The lead edge of the paper fai
Description: Failure To Calibrate RAP (W/O TAG 150) Initial Actions Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 14-703 to 14-706, 712, 714, 716, 718 Failure to Calibrate Entry RAP.
07-303A
Description: Tray 3 Open During Run RAP (W/O TAG 151)
11-450-171, 11-456-171 to 11-459-171
Description: HVF Ejector Module RAP 11-450-171 The ejector module motor has stalled 11-456-171 The ejector module did not return to the home position. 11-457-171 The ejector module did not move from the home position. 11-458-171 The ejector module did no
Xerox WorkCentre 5765 Common Errors
The most common error codes.
Error
10-132, 10-133, 10-134
Description: Lead Edge Late to Inverter Sensor RAP (65-90 ppm) 10-132 The lead edge of the paper failed to actuate the inverter sensor within the correct time after the fuser exit switch is made, for a simplex sheet. 10-133 The lead edge of the paper fai
Description: Failure To Calibrate RAP (W/O TAG 150) Initial Actions Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 14-703 to 14-706, 712, 714, 716, 718 Failure to Calibrate Entry RAP.
07-303A
Description: Tray 3 Open During Run RAP (W/O TAG 151)
11-450-171, 11-456-171 to 11-459-171
Description: HVF Ejector Module RAP 11-450-171 The ejector module motor has stalled 11-456-171 The ejector module did not return to the home position. 11-457-171 The ejector module did not move from the home position. 11-458-171 The ejector module did no
10-132, 10-133, 10-134
Description: Lead Edge Late to Inverter Sensor RAP (65-90 ppm) 10-132 The lead edge of the paper failed to actuate the inverter sensor within the correct time after the fuser exit switch is made, for a simplex sheet. 10-133 The lead edge of the paper fai
Description: Failure To Calibrate RAP (W/O TAG 150) Initial Actions Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 14-703 to 14-706, 712, 714, 716, 718 Failure to Calibrate Entry RAP.
07-303A
Description: Tray 3 Open During Run RAP (W/O TAG 151)
11-450-171, 11-456-171 to 11-459-171
Description: HVF Ejector Module RAP 11-450-171 The ejector module motor has stalled 11-456-171 The ejector module did not return to the home position. 11-457-171 The ejector module did not move from the home position. 11-458-171 The ejector module did no