Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox WorkCentre 5330 Top Searches

These results are ranked by popularity.

Error
092-315Description: ATC Fail RAP The frequency at which the ATC Average Fail or the ATC Amplitude Fail has been occurring has exceeded the threshold value. NOTE: • Although this Fault can be cleared by turning the power OFF and ON and it will be possible to out
041-310Description: IM Logic Fail RAP The IM (Image Management) software control error was detected.
012-291Description: (Integrated Finisher) Stapler Fail RAP Within a specified time after the Staple Motor started rotating in reverse direction, the Staple Head Home Sensor was never detected turning On.
077-214Description: Tray Module Logic Fail RAP I/F mismatch between the IOT and the Tray Module was detected.
005-940Description: DADF No Original RAP Operation Fail. Final document correction notification due to DADF document being pulled out.

Xerox WorkCentre 5330 Common Errors

The most common error codes.

Error
092-315Description: ATC Fail RAP The frequency at which the ATC Average Fail or the ATC Amplitude Fail has been occurring has exceeded the threshold value. NOTE: • Although this Fault can be cleared by turning the power OFF and ON and it will be possible to out
041-310Description: IM Logic Fail RAP The IM (Image Management) software control error was detected.
012-291Description: (Integrated Finisher) Stapler Fail RAP Within a specified time after the Staple Motor started rotating in reverse direction, the Staple Head Home Sensor was never detected turning On.
077-214Description: Tray Module Logic Fail RAP I/F mismatch between the IOT and the Tray Module was detected.
005-940Description: DADF No Original RAP Operation Fail. Final document correction notification due to DADF document being pulled out.
092-315Description: ATC Fail RAP The frequency at which the ATC Average Fail or the ATC Amplitude Fail has been occurring has exceeded the threshold value. NOTE: • Although this Fault can be cleared by turning the power OFF and ON and it will be possible to out
062-396Description: CCD Cable Connection Fail RAP A CCD Flat Cable connection error was detected.
041-310Description: IM Logic Fail RAP The IM (Image Management) software control error was detected.
077-214Description: Tray Module Logic Fail RAP I/F mismatch between the IOT and the Tray Module was detected.
005-940Description: DADF No Original RAP Operation Fail. Final document correction notification due to DADF document being pulled out.