Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox WorkCentre 5325 Top Searches

These results are ranked by popularity.

Error
012-280Description: (Integrated Finisher) Eject Home Sensor OFF Fail RAP In the Eject Motor’s initializing operation and ejecting operation, the Eject Motor had rotated forward for a time corresponding to a specified number of pulses since the Eject Home Sensor
005-199Description: Too Long Size Jam RAP It was detected that the document length in Slow Scan direction was out of the specifications. • Simplex and Duplex modes: 431.9mm or longer • Fax mode: 1501.0mm or longer
012-152Description: Compiler Exit Sensor On Jam RAP (LX) After the H-Transport Exit Sensor turned On, the Compiler Exit Sensor did not turn On within the specified time.
062-277Description: ESS-DADF Communication Fail RAP Communication cannot be established between the ESS PWB and the DADF PWB. NOTE: When turning the power OFF, turn OFF the power switch first and then the main power switch.
012-966Description: Scratch Sheet Compile RAP Paper was detected that was either out of spec, in poor condition (wrinkled, curled) and was ejected to the compiler.

Xerox WorkCentre 5325 Common Errors

The most common error codes.

Error
012-280Description: (Integrated Finisher) Eject Home Sensor OFF Fail RAP In the Eject Motor’s initializing operation and ejecting operation, the Eject Motor had rotated forward for a time corresponding to a specified number of pulses since the Eject Home Sensor
005-199Description: Too Long Size Jam RAP It was detected that the document length in Slow Scan direction was out of the specifications. • Simplex and Duplex modes: 431.9mm or longer • Fax mode: 1501.0mm or longer
012-152Description: Compiler Exit Sensor On Jam RAP (LX) After the H-Transport Exit Sensor turned On, the Compiler Exit Sensor did not turn On within the specified time.
062-277Description: ESS-DADF Communication Fail RAP Communication cannot be established between the ESS PWB and the DADF PWB. NOTE: When turning the power OFF, turn OFF the power switch first and then the main power switch.
012-966Description: Scratch Sheet Compile RAP Paper was detected that was either out of spec, in poor condition (wrinkled, curled) and was ejected to the compiler.
012-280Description: (Integrated Finisher) Eject Home Sensor OFF Fail RAP In the Eject Motor’s initializing operation and ejecting operation, the Eject Motor had rotated forward for a time corresponding to a specified number of pulses since the Eject Home Sensor
005-199Description: Too Long Size Jam RAP It was detected that the document length in Slow Scan direction was out of the specifications. • Simplex and Duplex modes: 431.9mm or longer • Fax mode: 1501.0mm or longer
012-152Description: Compiler Exit Sensor On Jam RAP (LX) After the H-Transport Exit Sensor turned On, the Compiler Exit Sensor did not turn On within the specified time.
062-277Description: ESS-DADF Communication Fail RAP Communication cannot be established between the ESS PWB and the DADF PWB. NOTE: When turning the power OFF, turn OFF the power switch first and then the main power switch.
024-960Description: Tray 2 Size Mismatch RAP The paper size in Tray 2 and the paper size specified for printing are different.