Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox WorkCentre 5225 Top Searches

These results are ranked by popularity.

Error
077-329Description: Main Motor Stop Error RAP Due to MCU PWB control failure, the Main Motor does not stop when no paper is being fed.
005-906Description: CVT Feed Sensor Static JAM RAP Paper remains on the DADF Feed Out Sensor.
024-916Description: (A-Finisher) Mix Stack Full , 12.8 In detection of Half Position (Mix Full position), one of the following is met: • Paper in the job is larger (longer in either lead/trail edge or side edge) than the last paper of the previous job. • The wi
072-210Description: Tray 2 Lift Up Failure RAP After the Tray 2 Feed/Lift Motor turned On, the Tray 2 Level Sensor did not turn On within the specified time.
003-319Description: IIT Video Driver Detection Failure RAP A Compression Threshold overflow, DMA Transfer error, or Other compression system errors were detected.

Xerox WorkCentre 5225 Common Errors

The most common error codes.

Error
077-329Description: Main Motor Stop Error RAP Due to MCU PWB control failure, the Main Motor does not stop when no paper is being fed.
005-906Description: CVT Feed Sensor Static JAM RAP Paper remains on the DADF Feed Out Sensor.
024-916Description: (A-Finisher) Mix Stack Full , 12.8 In detection of Half Position (Mix Full position), one of the following is met: • Paper in the job is larger (longer in either lead/trail edge or side edge) than the last paper of the previous job. • The wi
072-210Description: Tray 2 Lift Up Failure RAP After the Tray 2 Feed/Lift Motor turned On, the Tray 2 Level Sensor did not turn On within the specified time.
003-319Description: IIT Video Driver Detection Failure RAP A Compression Threshold overflow, DMA Transfer error, or Other compression system errors were detected.
077-329Description: Main Motor Stop Error RAP Due to MCU PWB control failure, the Main Motor does not stop when no paper is being fed.
005-906Description: CVT Feed Sensor Static JAM RAP Paper remains on the DADF Feed Out Sensor.
024-916Description: (A-Finisher) Mix Stack Full , 12.8 In detection of Half Position (Mix Full position), one of the following is met: • Paper in the job is larger (longer in either lead/trail edge or side edge) than the last paper of the previous job. • The wi
072-210Description: Tray 2 Lift Up Failure RAP After the Tray 2 Feed/Lift Motor turned On, the Tray 2 Level Sensor did not turn On within the specified time.
003-319Description: IIT Video Driver Detection Failure RAP A Compression Threshold overflow, DMA Transfer error, or Other compression system errors were detected.