Xerox WorkCentre 5022 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox WorkCentre 5022 Top Searches

These results are ranked by popularity.

Error
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
133-226Description: Fax Country or Clock Not Set When activating Fax at power ON, the country code setting is 'Unknown' or the clock is not set.
077-129Description: Regi Sensor On Jam (Duplex Wait) During the paper stop at the invert wait position at Duplex print, the Regi Sensor did not turn ON within the specified time after the Duplex Clutch On.
042-608Description: Voc Life Over BSD-ON: The Voc Filter is due for replacement
092-660, 092-668Description: ATC Amplitude Fail/ ATC Average Fail [ATC Amplitude Fail] The output amplitude of the ATC Sensor in the ATC (Automatic Toner Control) measurement is small. [ATC Average Fail] The average output value is not within the specified range in the

Xerox WorkCentre 5022 Common Errors

The most common error codes.

Error
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
133-226Description: Fax Country or Clock Not Set When activating Fax at power ON, the country code setting is 'Unknown' or the clock is not set.
077-129Description: Regi Sensor On Jam (Duplex Wait) During the paper stop at the invert wait position at Duplex print, the Regi Sensor did not turn ON within the specified time after the Duplex Clutch On.
042-608Description: Voc Life Over BSD-ON: The Voc Filter is due for replacement
092-660, 092-668Description: ATC Amplitude Fail/ ATC Average Fail [ATC Amplitude Fail] The output amplitude of the ATC Sensor in the ATC (Automatic Toner Control) measurement is small. [ATC Average Fail] The average output value is not within the specified range in the
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
077-129Description: Regi Sensor On Jam (Duplex Wait) During the paper stop at the invert wait position at Duplex print, the Regi Sensor did not turn ON within the specified time after the Duplex Clutch On.
042-608Description: Voc Life Over BSD-ON: The Voc Filter is due for replacement
133-226Description: Fax Country or Clock Not Set When activating Fax at power ON, the country code setting is 'Unknown' or the clock is not set.
072-102Description: Feed Out Sensor 2 On Jam During paper feed from Tray 2, the Feed Out Sensor 2 did not turn ON within the specified time after the Tray 2 Feed Motor On.