Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Xerox WorkCentre 5021 Top Searches

These results are ranked by popularity.

Error
093-406Description: Toner Pre Near Empty Preparation for replacing the Toner Cartridge is required.
062-371, 062-380Description: Lamp Illumination Fail/ AGC Fail [Lamp Illumination Fail] Insufficient light from Lamp detected in CCD. (During white gradation correction/AGC before Scan starts) [AGC Fail] Insufficient lamp brightness was detected when performing AGC.
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
016-502Description: UI Panel Download Flash Write Error Unable to write the Download File of UI Panel into the Flash ROM.
003-973Description: Auto Rotation NG Out Of Range During Copy Job, the following conditions were met. • Rotation is required. • The length of the image obtained by document x reduce/enlarge ratio is longer than 297 mm.

Xerox WorkCentre 5021 Common Errors

The most common error codes.

Error
093-406Description: Toner Pre Near Empty Preparation for replacing the Toner Cartridge is required.
062-371, 062-380Description: Lamp Illumination Fail/ AGC Fail [Lamp Illumination Fail] Insufficient light from Lamp detected in CCD. (During white gradation correction/AGC before Scan starts) [AGC Fail] Insufficient lamp brightness was detected when performing AGC.
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
016-502Description: UI Panel Download Flash Write Error Unable to write the Download File of UI Panel into the Flash ROM.
003-973Description: Auto Rotation NG Out Of Range During Copy Job, the following conditions were met. • Rotation is required. • The length of the image obtained by document x reduce/enlarge ratio is longer than 297 mm.
093-406Description: Toner Pre Near Empty Preparation for replacing the Toner Cartridge is required.
062-371, 062-380Description: Lamp Illumination Fail/ AGC Fail [Lamp Illumination Fail] Insufficient light from Lamp detected in CCD. (During white gradation correction/AGC before Scan starts) [AGC Fail] Insufficient lamp brightness was detected when performing AGC.
010-312Description: Fusing Unit Rear Thermistor Defect An open circuit abnormality (the AD value of the STS is equivalent to the open circuit value) of the Heat Roll Rear Thermistor was detected.
016-502Description: UI Panel Download Flash Write Error Unable to write the Download File of UI Panel into the Flash ROM.
003-973Description: Auto Rotation NG Out Of Range During Copy Job, the following conditions were met. • Rotation is required. • The length of the image obtained by document x reduce/enlarge ratio is longer than 297 mm.