Toshiba e-Studio 230L Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Toshiba e-Studio 230L Top Searches

These results are ranked by popularity.

Error
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
EAD0Description: Print end command time-out jam: The printing has not finished normally because of the communication error between the SYS board and LGC board at the end of printing.
CB50Description: Staple motor (staple/fold) abnormality: The staple motor is not rotating normally or the stapler is not moving normally. [MJ-1025]
E713Description: Stop jam at the original length sensor: The trailing edge of the original does not pass the original length sensor after its leading edge has reached this sensor.
F101Description: HDD unmounted: Connection of HDD cannot be detected.

Toshiba e-Studio 230L Common Errors

The most common error codes.

Error
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
EAD0Description: Print end command time-out jam: The printing has not finished normally because of the communication error between the SYS board and LGC board at the end of printing.
CB50Description: Staple motor (staple/fold) abnormality: The staple motor is not rotating normally or the stapler is not moving normally. [MJ-1025]
E713Description: Stop jam at the original length sensor: The trailing edge of the original does not pass the original length sensor after its leading edge has reached this sensor.
F101Description: HDD unmounted: Connection of HDD cannot be detected.
E200Description: Upper drawer transport jam (Paper not reaching the registration sensor): The paper does not reach the registration sensor after it has passed the 1st transport sensor.
EAD0Description: Print end command time-out jam: The printing has not finished normally because of the communication error between the SYS board and LGC board at the end of printing.
CB50Description: Staple motor (staple/fold) abnormality: The staple motor is not rotating normally or the stapler is not moving normally. [MJ-1025]
E713Description: Stop jam at the original length sensor: The trailing edge of the original does not pass the original length sensor after its leading edge has reached this sensor.
F101Description: HDD unmounted: Connection of HDD cannot be detected.