Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Toshiba e-Studio 202S Top Searches

These results are ranked by popularity.

Error
H4 00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" mea
E7 01Description: Duplex model memory setup error, memory not-detected error
L1 00Description: Feeding is not completed within the specified time after starting feeding. (The scan head locking switch is locked) Though the mirror base is shifted by about 30mm, the MHPS is not turned OFF.
E7 02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L3 00Description: Scanner return trouble. When the mirror base is returned for the specified time (6 sec) in mirror initializing after turning on the power, the mirror home position sensor (MHPS) does not turn ON. Or when the mirror base is returned for the s

Toshiba e-Studio 202S Common Errors

The most common error codes.

Error
H4 00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" mea
E7 01Description: Duplex model memory setup error, memory not-detected error
L1 00Description: Feeding is not completed within the specified time after starting feeding. (The scan head locking switch is locked) Though the mirror base is shifted by about 30mm, the MHPS is not turned OFF.
E7 02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L3 00Description: Scanner return trouble. When the mirror base is returned for the specified time (6 sec) in mirror initializing after turning on the power, the mirror home position sensor (MHPS) does not turn ON. Or when the mirror base is returned for the s
H4 00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" mea
E7 01Description: Duplex model memory setup error, memory not-detected error
L1 00Description: Feeding is not completed within the specified time after starting feeding. (The scan head locking switch is locked) Though the mirror base is shifted by about 30mm, the MHPS is not turned OFF.
E7 02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L3 00Description: Scanner return trouble. When the mirror base is returned for the specified time (6 sec) in mirror initializing after turning on the power, the mirror home position sensor (MHPS) does not turn ON. Or when the mirror base is returned for the s