Sharp MXM620 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp MXM620 Top Searches

These results are ranked by popularity.

Error
E7-55Description: Incompatibility check (55ppm) (Engine (PCU) detection) An error is detected in the internal incompatibility check in the engine (PCU).
U5-30Description: DSPF tray lift-up trouble Lift-up trouble is detected 5 times continuously.
H2-02Description: Thermistor open/Fusing unit not installed (HL3) Thermistor open (An input voltage of 4.6V or above is detected.) Fusing unit not installed
F1-51Description: Finisher/saddle sensor connector connection trouble The connector connection detection input of the guide HP sensor is off. The connector connection detection input of the push lead edge sensor is off.
L4-02Description: Drum motor lock detection The motor lock signal is detected for 1.5sec during rotation of the drum motor. When the motor lock signal is detected for 3 times continuously in the interval of 500ms after 900ms of rotation start.

Sharp MXM620 Common Errors

The most common error codes.

Error
E7-55Description: Incompatibility check (55ppm) (Engine (PCU) detection) An error is detected in the internal incompatibility check in the engine (PCU).
U5-30Description: DSPF tray lift-up trouble Lift-up trouble is detected 5 times continuously.
H2-02Description: Thermistor open/Fusing unit not installed (HL3) Thermistor open (An input voltage of 4.6V or above is detected.) Fusing unit not installed
F1-51Description: Finisher/saddle sensor connector connection trouble The connector connection detection input of the guide HP sensor is off. The connector connection detection input of the push lead edge sensor is off.
L4-02Description: Drum motor lock detection The motor lock signal is detected for 1.5sec during rotation of the drum motor. When the motor lock signal is detected for 3 times continuously in the interval of 500ms after 900ms of rotation start.
E7-55Description: Incompatibility check (55ppm) (Engine (PCU) detection) An error is detected in the internal incompatibility check in the engine (PCU).
U5-30Description: DSPF tray lift-up trouble Lift-up trouble is detected 5 times continuously.
H2-02Description: Thermistor open/Fusing unit not installed (HL3) Thermistor open (An input voltage of 4.6V or above is detected.) Fusing unit not installed
F1-51Description: Finisher/saddle sensor connector connection trouble The connector connection detection input of the guide HP sensor is off. The connector connection detection input of the push lead edge sensor is off.
L4-02Description: Drum motor lock detection The motor lock signal is detected for 1.5sec during rotation of the drum motor. When the motor lock signal is detected for 3 times continuously in the interval of 500ms after 900ms of rotation start.