Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp MXM350 Top Searches

These results are ranked by popularity.

Error
F1-00Description: Mail-bin stacker communication trouble Communication cable test error after turning on the power or exiting from SIM. Communication error with the Mail-bin stacker.
H2-00, H2-HL1, H2-01, H2-HL2Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1-32Description: Communication trouble between the console finisher and the punch unit. Communication err between the console finisher and the punch unit.
L8-02Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below)
F1-80Description: Mail-bin stacker power abnormality The 24V power is not supplied to the Mail-bin stacker PWB.

Sharp MXM350 Common Errors

The most common error codes.

Error
F1-00Description: Mail-bin stacker communication trouble Communication cable test error after turning on the power or exiting from SIM. Communication error with the Mail-bin stacker.
H2-00, H2-HL1, H2-01, H2-HL2Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1-32Description: Communication trouble between the console finisher and the punch unit. Communication err between the console finisher and the punch unit.
L8-02Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below)
F1-80Description: Mail-bin stacker power abnormality The 24V power is not supplied to the Mail-bin stacker PWB.
F1-00Description: Mail-bin stacker communication trouble Communication cable test error after turning on the power or exiting from SIM. Communication error with the Mail-bin stacker.
H2-00, H2-HL1, H2-01, H2-HL2Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1-32Description: Communication trouble between the console finisher and the punch unit. Communication err between the console finisher and the punch unit.
L8-02Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below)
F1-80Description: Mail-bin stacker power abnormality The 24V power is not supplied to the Mail-bin stacker PWB.