These results are ranked by popularity.
| Error | |
|---|---|
| F2-04 | Description: Identification error Model error Type error Destination error Data abnormality Misc error (Identification error) When the CRUM trademark differs. When the CRUM company code differs. (Model error) When the boot program model code does not mat |
| H5-01 | Description: 10 times of continuous detection of the lower paper exit sensor (POD1) lead edge jam or the upper paper exit sensor (POD2) lead edge jam or the duplex sensor (PPD2) rear edge jam After supplying the power, one of the above jams occurs 10 ti |
| U1-01 | Description: FAX battery error The SRAM backup battery voltage on FAX control PWB falls. |
| F6-96 | Description: Combination error between the MCU and the FAX firmware. The version of the FAX firmware is not changed “04.xx” or later. |
| E1-80 | Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error) |
The most common error codes.
| Error | |
|---|---|
| F2-04 | Description: Identification error Model error Type error Destination error Data abnormality Misc error (Identification error) When the CRUM trademark differs. When the CRUM company code differs. (Model error) When the boot program model code does not mat |
| H5-01 | Description: 10 times of continuous detection of the lower paper exit sensor (POD1) lead edge jam or the upper paper exit sensor (POD2) lead edge jam or the duplex sensor (PPD2) rear edge jam After supplying the power, one of the above jams occurs 10 ti |
| U1-01 | Description: FAX battery error The SRAM backup battery voltage on FAX control PWB falls. |
| F6-96 | Description: Combination error between the MCU and the FAX firmware. The version of the FAX firmware is not changed “04.xx” or later. |
| E1-80 | Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error) |
| F2-04 | Description: Identification error Model error Type error Destination error Data abnormality Misc error (Identification error) When the CRUM trademark differs. When the CRUM company code differs. (Model error) When the boot program model code does not mat |
| H5-01 | Description: 10 times of continuous detection of the lower paper exit sensor (POD1) lead edge jam or the upper paper exit sensor (POD2) lead edge jam or the duplex sensor (PPD2) rear edge jam After supplying the power, one of the above jams occurs 10 ti |
| U1-01 | Description: FAX battery error The SRAM backup battery voltage on FAX control PWB falls. |
| F6-96 | Description: Combination error between the MCU and the FAX firmware. The version of the FAX firmware is not changed “04.xx” or later. |
| E1-80 | Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error) |
