Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp MXM260 Top Searches

These results are ranked by popularity.

Error
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in finisher communication
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main thermistor causes abnormally high temperature (over 230°C).
L4-31Description: Fusing fan lock trouble Fusing fan does not rotate. The fusing fan lock signal is detected for 1sec or more.
A0-01Description: Security incompatibility error When the PCL or the FAX control PWB is installed, it does not match with compatible/incompatible setup of the MCU PWB security.
L8-10Description: Power abnormality detection trouble The power status monitoring signal keeps power OFF state after passing the specified time (2sec).

Sharp MXM260 Common Errors

The most common error codes.

Error
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in finisher communication
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main thermistor causes abnormally high temperature (over 230°C).
L4-31Description: Fusing fan lock trouble Fusing fan does not rotate. The fusing fan lock signal is detected for 1sec or more.
A0-01Description: Security incompatibility error When the PCL or the FAX control PWB is installed, it does not match with compatible/incompatible setup of the MCU PWB security.
L8-10Description: Power abnormality detection trouble The power status monitoring signal keeps power OFF state after passing the specified time (2sec).
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in finisher communication
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main thermistor causes abnormally high temperature (over 230°C).
L4-31Description: Fusing fan lock trouble Fusing fan does not rotate. The fusing fan lock signal is detected for 1sec or more.
A0-01Description: Security incompatibility error When the PCL or the FAX control PWB is installed, it does not match with compatible/incompatible setup of the MCU PWB security.
L8-10Description: Power abnormality detection trouble The power status monitoring signal keeps power OFF state after passing the specified time (2sec).