Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp MXB200 Top Searches

These results are ranked by popularity.

Error
E7 16Description: Abnormal laser output. When the laser output is stopped, HSYNC is detected.
H3 00Description: Heat roller high temperature detection. The fusing temperature exceeds 240°C.
E1 00Description: Network board communication trouble. An abnormality occurs in communication between the MCU and the network board.
E7 20Description: LSU trouble. The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
H4 00Description: Heat roller low temperature detection. 1) When the target temperature (165C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100C is detected for 300ms under the ready print state. . "Starting warming-up" me

Sharp MXB200 Common Errors

The most common error codes.

Error
E7 16Description: Abnormal laser output. When the laser output is stopped, HSYNC is detected.
H3 00Description: Heat roller high temperature detection. The fusing temperature exceeds 240°C.
E1 00Description: Network board communication trouble. An abnormality occurs in communication between the MCU and the network board.
E7 20Description: LSU trouble. The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
H4 00Description: Heat roller low temperature detection. 1) When the target temperature (165C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100C is detected for 300ms under the ready print state. . "Starting warming-up" me
E7 16Description: Abnormal laser output. When the laser output is stopped, HSYNC is detected.
H3 00Description: Heat roller high temperature detection. The fusing temperature exceeds 240°C.
E1 00Description: Network board communication trouble. An abnormality occurs in communication between the MCU and the network board.
E7 20Description: LSU trouble. The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
H4 00Description: Heat roller low temperature detection. 1) When the target temperature (165C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100C is detected for 300ms under the ready print state. . "Starting warming-up" me