Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARP350 Top Searches

These results are ranked by popularity.

Error
H2 01, H2 HL2Description: thermistor open Fusing unit not installed. Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1 19Description: Finisher (AR-FN6) front alignment motor trouble. Front alignment motor operation abnormality
F1 34Description: Console finisher (AR-FN7) punch (AR-PN1) motor trouble. Punch motor operation abnormality
F1 00Description: Finisher (AR-FN6) communication trouble. Communication cable test error after turning on the power or exiting from DIAG. Communication error with the finisher
PF 00Description: RIC copy inhibit signal is received. Copy inhibit command from RIM (host) is received.

Sharp ARP350 Common Errors

The most common error codes.

Error
H2 01, H2 HL2Description: thermistor open Fusing unit not installed. Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1 19Description: Finisher (AR-FN6) front alignment motor trouble. Front alignment motor operation abnormality
F1 34Description: Console finisher (AR-FN7) punch (AR-PN1) motor trouble. Punch motor operation abnormality
F1 00Description: Finisher (AR-FN6) communication trouble. Communication cable test error after turning on the power or exiting from DIAG. Communication error with the finisher
PF 00Description: RIC copy inhibit signal is received. Copy inhibit command from RIM (host) is received.
H2 01, H2 HL2Description: thermistor open Fusing unit not installed. Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
F1 19Description: Finisher (AR-FN6) front alignment motor trouble. Front alignment motor operation abnormality
F1 34Description: Console finisher (AR-FN7) punch (AR-PN1) motor trouble. Punch motor operation abnormality
F1 00Description: Finisher (AR-FN6) communication trouble. Communication cable test error after turning on the power or exiting from DIAG. Communication error with the finisher
PF 00Description: RIC copy inhibit signal is received. Copy inhibit command from RIM (host) is received.