Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARM355 Top Searches

These results are ranked by popularity.

Error
E7-60Description: Controller skating trouble Occurrence of an error in controller skating check
F1-20Description: Console finisher rear alignment motor trouble Rear alignment motor operation abnormality
H4Description: Fusing section low temperature trouble The set temperature is not reached within the specified time (3 min) after turning on the power relay, or the temperature does not reach 80°C within 80 sec. When the heater lamp is not turned off in the
F1-02Description: Mail-bin stacker transport motor abnormality Transport motor trouble
U2-12Description: Adjustment value check sum error (ICU) Adjustment data area check sum error

Sharp ARM355 Common Errors

The most common error codes.

Error
E7-60Description: Controller skating trouble Occurrence of an error in controller skating check
F1-20Description: Console finisher rear alignment motor trouble Rear alignment motor operation abnormality
H4Description: Fusing section low temperature trouble The set temperature is not reached within the specified time (3 min) after turning on the power relay, or the temperature does not reach 80°C within 80 sec. When the heater lamp is not turned off in the
F1-02Description: Mail-bin stacker transport motor abnormality Transport motor trouble
U2-12Description: Adjustment value check sum error (ICU) Adjustment data area check sum error
E7-60Description: Controller skating trouble Occurrence of an error in controller skating check
F1-20Description: Console finisher rear alignment motor trouble Rear alignment motor operation abnormality
H4Description: Fusing section low temperature trouble The set temperature is not reached within the specified time (3 min) after turning on the power relay, or the temperature does not reach 80°C within 80 sec. When the heater lamp is not turned off in the
F1-40Description: Console finisher punch power interruption trouble When power interruption of the punch unit is detected
C1-00Description: MC trouble Main charger output abnormality (Output open) Trouble signal is outputted from the high voltage transformer.