Sharp ARM318 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARM318 Top Searches

These results are ranked by popularity.

Error
F1-30Description: Finisher interface error Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in console finisher communication
U9-82Description: Operation control PWB communication trouble (Overrun) Communication trouble between MCU and the operation control PWB (Overrun error)
F9-84Description: Printer PWB communication trouble (Framing) Communication trouble between MCU and printer PWB (Framing error)
H4-00Description: Main heater lamp abnormally low temperature detection The setup temperature (about 90°C) is not reached within the specified time (about 17sec) from turning on the power ON SW. (When the temperature of main heater lamp thermistor falls below
F1-50Description: Finisher incompatibility error Speed does not coincide between finisher and main unit

Sharp ARM318 Common Errors

The most common error codes.

Error
F1-30Description: Finisher interface error Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in console finisher communication
U9-82Description: Operation control PWB communication trouble (Overrun) Communication trouble between MCU and the operation control PWB (Overrun error)
F9-84Description: Printer PWB communication trouble (Framing) Communication trouble between MCU and printer PWB (Framing error)
H4-00Description: Main heater lamp abnormally low temperature detection The setup temperature (about 90°C) is not reached within the specified time (about 17sec) from turning on the power ON SW. (When the temperature of main heater lamp thermistor falls below
F1-50Description: Finisher incompatibility error Speed does not coincide between finisher and main unit
F1-30Description: Finisher interface error Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in console finisher communication
U9-82Description: Operation control PWB communication trouble (Overrun) Communication trouble between MCU and the operation control PWB (Overrun error)
F9-84Description: Printer PWB communication trouble (Framing) Communication trouble between MCU and printer PWB (Framing error)
H4-00Description: Main heater lamp abnormally low temperature detection The setup temperature (about 90°C) is not reached within the specified time (about 17sec) from turning on the power ON SW. (When the temperature of main heater lamp thermistor falls below
F1-50Description: Finisher incompatibility error Speed does not coincide between finisher and main unit