Sharp ARM256 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARM256 Top Searches

These results are ranked by popularity.

Error
E1-84Description: IMC PWB communication trouble (Framing) Communication trouble between MCU and IMC PWB (Framing error)
H4-21Description: Sub heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the standb
F2-02Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
U2-04Description: EEPROM communication error MCU PWB EEPROM access circuit failure
F6-95Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier

Sharp ARM256 Common Errors

The most common error codes.

Error
E1-84Description: IMC PWB communication trouble (Framing) Communication trouble between MCU and IMC PWB (Framing error)
H4-21Description: Sub heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the standb
F2-02Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
U2-04Description: EEPROM communication error MCU PWB EEPROM access circuit failure
F6-95Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier
E1-84Description: IMC PWB communication trouble (Framing) Communication trouble between MCU and IMC PWB (Framing error)
H4-21Description: Sub heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the standb
F2-02Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
U2-04Description: EEPROM communication error MCU PWB EEPROM access circuit failure
F6-95Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier