Sharp ARM236 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARM236 Top Searches

These results are ranked by popularity.

Error
U2-20Description: Machine speed code data error The machine (Boot) speed information is not identical to the model code speed information.
F6-10Description: FAX control PWB trouble Communication trouble between MCU and FAX control PWB
H2-00Description: Main heater lamp thermistor open hard detection Main heater lamp thermistor open detection Fusing unit not installed
E1-80Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error)
L1-00Description: Scanner feed trouble Scanner feed is not completed within the specified time.

Sharp ARM236 Common Errors

The most common error codes.

Error
U2-20Description: Machine speed code data error The machine (Boot) speed information is not identical to the model code speed information.
F6-10Description: FAX control PWB trouble Communication trouble between MCU and FAX control PWB
H2-00Description: Main heater lamp thermistor open hard detection Main heater lamp thermistor open detection Fusing unit not installed
E1-80Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error)
L1-00Description: Scanner feed trouble Scanner feed is not completed within the specified time.
F6-10Description: FAX control PWB trouble Communication trouble between MCU and FAX control PWB
U2-20Description: Machine speed code data error The machine (Boot) speed information is not identical to the model code speed information.
E1-80Description: IMC PWB communication trouble (protocol) Communication trouble between MCU and IMC PWB (Protocol error)
H2-00Description: Main heater lamp thermistor open hard detection Main heater lamp thermistor open detection Fusing unit not installed
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication