Sharp ARM200 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp ARM200 Top Searches

These results are ranked by popularity.

Error
H4-00Description: Heat roller low temperature detection When the fusing temperature is lower than 150C° after 55sec from the start of warming up. When the warming up complete temperature is not reached in 30sec from reaching 150C°. When the fusing temperature
E7-02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L1-00Description: Scanner feed trouble The scanner does not complete feeding in the specified time.
E7-10Description: Shading trouble (Black correction) The CCD black scan level is abnormal when the shading.
L3-00Description: Scanner return trouble The scanner does not complete returning in the specified time. The mirror is not in the home position when OC copying is started with the mirror standby in the home position.

Sharp ARM200 Common Errors

The most common error codes.

Error
H4-00Description: Heat roller low temperature detection When the fusing temperature is lower than 150C° after 55sec from the start of warming up. When the warming up complete temperature is not reached in 30sec from reaching 150C°. When the fusing temperature
E7-02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L1-00Description: Scanner feed trouble The scanner does not complete feeding in the specified time.
E7-10Description: Shading trouble (Black correction) The CCD black scan level is abnormal when the shading.
L3-00Description: Scanner return trouble The scanner does not complete returning in the specified time. The mirror is not in the home position when OC copying is started with the mirror standby in the home position.
H4-00Description: Heat roller low temperature detection When the fusing temperature is lower than 150C° after 55sec from the start of warming up. When the warming up complete temperature is not reached in 30sec from reaching 150C°. When the fusing temperature
E7-02Description: LSU trouble The BD signal from the LSU cannot be detected in a certain cycle. (Always OFF or always ON)
L1-00Description: Scanner feed trouble The scanner does not complete feeding in the specified time.
E7-10Description: Shading trouble (Black correction) The CCD black scan level is abnormal when the shading.
L3-00Description: Scanner return trouble The scanner does not complete returning in the specified time. The mirror is not in the home position when OC copying is started with the mirror standby in the home position.