Sharp AR501 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AR501 Top Searches

These results are ranked by popularity.

Error
U5 08Description: RSPF SB sensor detection trouble (in auto adjustment)
F9 03Description: Network card trouble. Network card self test trouble.
E7 11Description: Shading trouble (white correction). Improper CCD white reference plate reading level for copy lamp lighting
H4 01, H4 HL2Description: Heat roller low temperature detection. The temperature does not reach the preset value within the specified time (3 min. in usual modes; 5 min. in curl correction mode.) after the power relay is turned on.
F1 06Description: Finisher shift motor abnormality. 1) Bin shift is not completed within 2.5 seconds after bin shift request

Sharp AR501 Common Errors

The most common error codes.

Error
U5 08Description: RSPF SB sensor detection trouble (in auto adjustment)
F9 03Description: Network card trouble. Network card self test trouble.
E7 11Description: Shading trouble (white correction). Improper CCD white reference plate reading level for copy lamp lighting
H4 01, H4 HL2Description: Heat roller low temperature detection. The temperature does not reach the preset value within the specified time (3 min. in usual modes; 5 min. in curl correction mode.) after the power relay is turned on.
F1 06Description: Finisher shift motor abnormality. 1) Bin shift is not completed within 2.5 seconds after bin shift request
U5 08Description: RSPF SB sensor detection trouble (in auto adjustment)
F9 03Description: Network card trouble. Network card self test trouble.
E7 11Description: Shading trouble (white correction). Improper CCD white reference plate reading level for copy lamp lighting
H4 01, H4 HL2Description: Heat roller low temperature detection. The temperature does not reach the preset value within the specified time (3 min. in usual modes; 5 min. in curl correction mode.) after the power relay is turned on.
F1 06Description: Finisher shift motor abnormality. 1) Bin shift is not completed within 2.5 seconds after bin shift request