Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AR450LP Top Searches

These results are ranked by popularity.

Error
E7 02Description: Laser trouble. BD signal from LSU is kept OFF, or ON.
H4 01, H4HL2Description: Fusing section low temperature trouble. •The set temperature is not reached within the specified time (normally 3 min) when warming up or resetting from pre-heating. •Under the ready state. (An input voltage of 1.21V or below is detected 5 t
F1 20Description: Finisher (AR-FN6) rear alignment motor trouble. Rear alignment motor operation abnormality
U2 12Description: Adjustment value check sum error (Controller)
F1 38Description: Console finisher (AR-FN7) punch (AR-PN1) backup RAM trouble. Punch unit backup RAM contents are disturbed.

Sharp AR450LP Common Errors

The most common error codes.

Error
E7 02Description: Laser trouble. BD signal from LSU is kept OFF, or ON.
H4 01, H4HL2Description: Fusing section low temperature trouble. •The set temperature is not reached within the specified time (normally 3 min) when warming up or resetting from pre-heating. •Under the ready state. (An input voltage of 1.21V or below is detected 5 t
F1 20Description: Finisher (AR-FN6) rear alignment motor trouble. Rear alignment motor operation abnormality
U2 12Description: Adjustment value check sum error (Controller)
F1 38Description: Console finisher (AR-FN7) punch (AR-PN1) backup RAM trouble. Punch unit backup RAM contents are disturbed.
E7 02Description: Laser trouble. BD signal from LSU is kept OFF, or ON.
H4 01, H4HL2Description: Fusing section low temperature trouble. •The set temperature is not reached within the specified time (normally 3 min) when warming up or resetting from pre-heating. •Under the ready state. (An input voltage of 1.21V or below is detected 5 t
F1 20Description: Finisher (AR-FN6) rear alignment motor trouble. Rear alignment motor operation abnormality
U2 12Description: Adjustment value check sum error (Controller)
F1 38Description: Console finisher (AR-FN7) punch (AR-PN1) backup RAM trouble. Punch unit backup RAM contents are disturbed.