These results are ranked by popularity.
| Error | |
|---|---|
| F1 11 | Description: Finisher 1 pusher motor trouble / Finisher 2 boomerang rotation abnormality. Pusher motor trouble / Paddle solenoid abnormality |
| U9 00 | Description: Operation control communication trouble (ICU detection). Communication setup error, framing/parity/protocol error |
| L1 00 | Description: Scanner feed trouble. Scanner feed is not finished within the specified time. (timer is change by magnification) |
| U4 03 | Description: ADU rear edge plate operation abnormality. When the plate is not shifted from the home position for 1 sec or more or when returning to the home position is not detected for 5 sec or more. |
| F2 32 | Description: Process control trouble (Drum marking scanning trouble). Usually the sensor gain is adjusted so that the output is a certain value, by reading the drum base surface with the drum marking sensor before starting process control. However, a cer |
The most common error codes.
| Error | |
|---|---|
| F1 11 | Description: Finisher 1 pusher motor trouble / Finisher 2 boomerang rotation abnormality. Pusher motor trouble / Paddle solenoid abnormality |
| U9 00 | Description: Operation control communication trouble (ICU detection). Communication setup error, framing/parity/protocol error |
| L1 00 | Description: Scanner feed trouble. Scanner feed is not finished within the specified time. (timer is change by magnification) |
| U4 03 | Description: ADU rear edge plate operation abnormality. When the plate is not shifted from the home position for 1 sec or more or when returning to the home position is not detected for 5 sec or more. |
| F2 32 | Description: Process control trouble (Drum marking scanning trouble). Usually the sensor gain is adjusted so that the output is a certain value, by reading the drum base surface with the drum marking sensor before starting process control. However, a cer |
| F1 11 | Description: Finisher 1 pusher motor trouble / Finisher 2 boomerang rotation abnormality. Pusher motor trouble / Paddle solenoid abnormality |
| U9 00 | Description: Operation control communication trouble (ICU detection). Communication setup error, framing/parity/protocol error |
| L1 00 | Description: Scanner feed trouble. Scanner feed is not finished within the specified time. (timer is change by magnification) |
| U4 03 | Description: ADU rear edge plate operation abnormality. When the plate is not shifted from the home position for 1 sec or more or when returning to the home position is not detected for 5 sec or more. |
| F2 32 | Description: Process control trouble (Drum marking scanning trouble). Usually the sensor gain is adjusted so that the output is a certain value, by reading the drum base surface with the drum marking sensor before starting process control. However, a cer |
