These results are ranked by popularity.
Error | |
---|---|
U9-88 | Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error) |
F1-08 | Description: Staple motor error The staple motor cannot return to the home position. |
F2-02 | Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value. |
F6-95 | Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier |
H4-20 | Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand |
The most common error codes.
Error | |
---|---|
U9-88 | Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error) |
F1-08 | Description: Staple motor error The staple motor cannot return to the home position. |
F2-02 | Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value. |
F6-95 | Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier |
H4-20 | Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand |
U9-88 | Description: Operation control PWB communication trouble (Time-out) Communication trouble between MCU and the operation PWB (Time-out error) |
F1-08 | Description: Staple motor error The staple motor cannot return to the home position. |
F2-02 | Description: Toner supply failure The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value. |
F6-95 | Description: Incompatibility error of AR-F14N and FAX control PWB FAX control PWB incompatible with ARF14N and AR-F14N was installed to the copier |
H4-20 | Description: Main heater lamp abnormally low temperature detection The setup temperature (about 25°C: Sim 43-1-1) is not reached within the specified time (about 32sec) from turning on the power ON SW. (When the temperature falls below 140°C in the stand |