These results are ranked by popularity.
Error | |
---|---|
E7-90 | Description: Communication trouble (ICU detection) between ICU and PCU Communication establishment error/ Fleming/Parity/Protocol error |
H2 | Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed |
F1-19 | Description: Console finisher front alignment motor trouble Front alignment motor operation abnormality |
L8-02 | Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below) |
F1-36 | Description: Console finisher punch timing sensor trouble Sensor input value abnormality |
The most common error codes.
Error | |
---|---|
E7-90 | Description: Communication trouble (ICU detection) between ICU and PCU Communication establishment error/ Fleming/Parity/Protocol error |
H2 | Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed |
F1-19 | Description: Console finisher front alignment motor trouble Front alignment motor operation abnormality |
L8-02 | Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below) |
F1-36 | Description: Console finisher punch timing sensor trouble Sensor input value abnormality |
E7-90 | Description: Communication trouble (ICU detection) between ICU and PCU Communication establishment error/ Fleming/Parity/Protocol error |
H2 | Description: Thermistor open Fusing unit not installed Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed |
F1-19 | Description: Console finisher front alignment motor trouble Front alignment motor operation abnormality |
L8-02 | Description: Full wave signal width abnormality It is judged as full wave signal frequency abnormality. (When the detection cycle is judged as 69Hz or above or 42.5Hz or below) |
F1-36 | Description: Console finisher punch timing sensor trouble Sensor input value abnormality |