Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AR286 Top Searches

These results are ranked by popularity.

Error
U5 02Description: RADF eject/inversion sensor detection trouble
F3 12Description: Copier top stage CS lift up trouble. UPED does not turn on within the specified time. ULUD does not turn on within the specified time.
E7 01Description: Image data memory trouble. The ICU image data memory (SIMM) is detected only as 8MB or less. The SIMM capacity is insufficient for the model.
U6 10Description: Desk transport motor operation trouble
H2 01, H2 HL2Description: Thermister open Fusing unit not installed. Thermister is open (more than 4.6-V input voltage is detected). Fusing unit not installed

Sharp AR286 Common Errors

The most common error codes.

Error
U5 02Description: RADF eject/inversion sensor detection trouble
F3 12Description: Copier top stage CS lift up trouble. UPED does not turn on within the specified time. ULUD does not turn on within the specified time.
E7 01Description: Image data memory trouble. The ICU image data memory (SIMM) is detected only as 8MB or less. The SIMM capacity is insufficient for the model.
U6 10Description: Desk transport motor operation trouble
H2 01, H2 HL2Description: Thermister open Fusing unit not installed. Thermister is open (more than 4.6-V input voltage is detected). Fusing unit not installed
U5 02Description: RADF eject/inversion sensor detection trouble
F3 12Description: Copier top stage CS lift up trouble. UPED does not turn on within the specified time. ULUD does not turn on within the specified time.
E7 01Description: Image data memory trouble. The ICU image data memory (SIMM) is detected only as 8MB or less. The SIMM capacity is insufficient for the model.
U6 10Description: Desk transport motor operation trouble
H2 01, H2 HL2Description: Thermister open Fusing unit not installed. Thermister is open (more than 4.6-V input voltage is detected). Fusing unit not installed