Sharp AR267FG Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AR267FG Top Searches

These results are ranked by popularity.

Error
U9-80Description: Operation control PWB communication trouble (Protocol) Communication trouble between MCU and the operation control PWB (Protocol error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F6-99Description: FAX control PWB destination error The machine destination setup does not coincide with the FAX board destination setup.
F1-31Description: Fold sensor trouble Sensor input value abnormality
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main heater lamp thermistor causes abnormally high temperature (over 230°C).

Sharp AR267FG Common Errors

The most common error codes.

Error
U9-80Description: Operation control PWB communication trouble (Protocol) Communication trouble between MCU and the operation control PWB (Protocol error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F6-99Description: FAX control PWB destination error The machine destination setup does not coincide with the FAX board destination setup.
F1-31Description: Fold sensor trouble Sensor input value abnormality
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main heater lamp thermistor causes abnormally high temperature (over 230°C).
U9-80Description: Operation control PWB communication trouble (Protocol) Communication trouble between MCU and the operation control PWB (Protocol error)
F1-00Description: Finisher communication trouble Communication line test error occurs when power is turned on or after the exit of a simulation mode. Error in Finisher communication
F6-99Description: FAX control PWB destination error The machine destination setup does not coincide with the FAX board destination setup.
F1-31Description: Fold sensor trouble Sensor input value abnormality
H3-10Description: Main heater lamp abnormally high temperature soft detection trouble A/D value the fusing main heater lamp thermistor causes abnormally high temperature (over 230°C).