Sharp AL2060 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Sharp AL2060 Top Searches

These results are ranked by popularity.

Error
U2-11Description: Counter check sum error (EEPROM) Check sum error of the counter area in the EEPROM
F5-02Description: Copy lamp lighting abnormality The copy lamp does not turn on.
H2-00Description: Thermistor open The thermistor is open. The fusing unit is not installed.
H3-00Description: Heat roller high temperature detection The fusing temperature exceeds 240°C.
H4-00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" me

Sharp AL2060 Common Errors

The most common error codes.

Error
U2-11Description: Counter check sum error (EEPROM) Check sum error of the counter area in the EEPROM
F5-02Description: Copy lamp lighting abnormality The copy lamp does not turn on.
H2-00Description: Thermistor open The thermistor is open. The fusing unit is not installed.
H3-00Description: Heat roller high temperature detection The fusing temperature exceeds 240°C.
H4-00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" me
U2-11Description: Counter check sum error (EEPROM) Check sum error of the counter area in the EEPROM
F5-02Description: Copy lamp lighting abnormality The copy lamp does not turn on.
H2-00Description: Thermistor open The thermistor is open. The fusing unit is not installed.
H3-00Description: Heat roller high temperature detection The fusing temperature exceeds 240°C.
H4-00Description: Heat roller low temperature detection 1) When the target temperature (165°C) is not reached in 55 sec after starting warming-up. 2) When the temperature below 100°C is detected for 300ms under the ready print state. "Starting warming-up" me