Roland CJ540 CammJet proII Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Roland CJ540 CammJet proII Top Searches

These results are ranked by popularity.

Error
0107Description: Unset up of the Linear Encoder Linear Encoder Setup has not been done.
0008Description: Feed Motor Overcurrent Error 2 (A little load is put on the motor for a long time.)
0108Description: Wiper Unit Protection Error Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not become to reach the expected value.
0010Description: Scan Motor Deviation Error
0109Description: Wiper Protection Error Even though the machine carries out the regular movement, the output of the Wiper Sensor does not reach the expected value.

Roland CJ540 CammJet proII Common Errors

The most common error codes.

Error
0107Description: Unset up of the Linear Encoder Linear Encoder Setup has not been done.
0008Description: Feed Motor Overcurrent Error 2 (A little load is put on the motor for a long time.)
0108Description: Wiper Unit Protection Error Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not become to reach the expected value.
0010Description: Scan Motor Deviation Error
0109Description: Wiper Protection Error Even though the machine carries out the regular movement, the output of the Wiper Sensor does not reach the expected value.
0107Description: Unset up of the Linear Encoder Linear Encoder Setup has not been done.
0008Description: Feed Motor Overcurrent Error 2 (A little load is put on the motor for a long time.)
0108Description: Wiper Unit Protection Error Even though the machine carries out the regular movement, the output of the Wiper Height Sensor does not become to reach the expected value.
0010Description: Scan Motor Deviation Error
0109Description: Wiper Protection Error Even though the machine carries out the regular movement, the output of the Wiper Sensor does not reach the expected value.