These results are ranked by popularity.
| Error | |
|---|---|
| T13 221 | Description: • Cutter does not operate normally. • Master was not cut properly. |
| T20 416 | Description: • Paper ejection wing does not operate properly. • Paper ejection motor is overloaded. |
| T96 433 | Description: • The information to be set in the test mode is not set. • The relationship between values set in the test mode are not correct. |
| F62 956 | Description: • An error has occurred on RLP. |
| T02 407 | Description: • The Paper feed tray is not in proper position. • Paper feed tray elevator motor is overloaded. |
The most common error codes.
| Error | |
|---|---|
| T13 221 | Description: • Cutter does not operate normally. • Master was not cut properly. |
| T20 416 | Description: • Paper ejection wing does not operate properly. • Paper ejection motor is overloaded. |
| T96 433 | Description: • The information to be set in the test mode is not set. • The relationship between values set in the test mode are not correct. |
| F62 956 | Description: • An error has occurred on RLP. |
| T02 407 | Description: • The Paper feed tray is not in proper position. • Paper feed tray elevator motor is overloaded. |
| F62 956 | Description: • An error has occurred on RLP. |
| T13 221 | Description: • Cutter does not operate normally. • Master was not cut properly. |
| T20 416 | Description: • Paper ejection wing does not operate properly. • Paper ejection motor is overloaded. |
| T96 433 | Description: • The information to be set in the test mode is not set. • The relationship between values set in the test mode are not correct. |
| D22 540 | Description: • Print drum EEPROM reading/writing has failed. • Print drum EEPROM data is not correct. |
