Ricoh MP1610L Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh MP1610L Top Searches

These results are ranked by popularity.

Error
559Description: Jam error detected 3 times in succession The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP 1159 1 is set to ‘on’. The default is ‘off’.
761Description: ADF gate abnormal 2 The FGATE signal is not issued from the ADF within 30 seconds after the ADF starts feeding.
390Description: TD sensor error The TD sensor outputs less than 0.2 V or more than 4.0 V 10 times consecutively during copying.
543Description: Fusing overheat error (center) The fusing temperature is over 230°C and continues 10 times consecutively. (100ms x 10 = 1 second). (detected by the thermistor).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.

Ricoh MP1610L Common Errors

The most common error codes.

Error
559Description: Jam error detected 3 times in succession The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP 1159 1 is set to ‘on’. The default is ‘off’.
761Description: ADF gate abnormal 2 The FGATE signal is not issued from the ADF within 30 seconds after the ADF starts feeding.
390Description: TD sensor error The TD sensor outputs less than 0.2 V or more than 4.0 V 10 times consecutively during copying.
543Description: Fusing overheat error (center) The fusing temperature is over 230°C and continues 10 times consecutively. (100ms x 10 = 1 second). (detected by the thermistor).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.
559Description: Jam error detected 3 times in succession The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP 1159 1 is set to ‘on’. The default is ‘off’.
761Description: ADF gate abnormal 2 The FGATE signal is not issued from the ADF within 30 seconds after the ADF starts feeding.
390Description: TD sensor error The TD sensor outputs less than 0.2 V or more than 4.0 V 10 times consecutively during copying.
543Description: Fusing overheat error (center) The fusing temperature is over 230°C and continues 10 times consecutively. (100ms x 10 = 1 second). (detected by the thermistor).
101Description: Exposure Lamp Error The standard white level was not detected properly when scanning the white plate.