Ricoh DD4450P Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh DD4450P Top Searches

These results are ranked by popularity.

Error
E-71Description: DF connect error ADF model code that is different from the code for this machine is received."
E-17Description: Drum Thermistor Open The thermistor output voltage is over 2.67 volts.
E-47Description: Thermal head driving error The thermal head HP sensor does not change status within 4.0 seconds after the thermal head driving motor on signal is generated.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.

Ricoh DD4450P Common Errors

The most common error codes.

Error
E-71Description: DF connect error ADF model code that is different from the code for this machine is received."
E-17Description: Drum Thermistor Open The thermistor output voltage is over 2.67 volts.
E-47Description: Thermal head driving error The thermal head HP sensor does not change status within 4.0 seconds after the thermal head driving motor on signal is generated.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.
E-71Description: DF connect error ADF model code that is different from the code for this machine is received."
E-17Description: Drum Thermistor Open The thermistor output voltage is over 2.67 volts.
E-47Description: Thermal head driving error The thermal head HP sensor does not change status within 4.0 seconds after the thermal head driving motor on signal is generated.
E-00Description: Clamper error The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-18Description: Drum Overheat The temperature of the drum is greater than 54C when the Start key is pressed.