Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Ricoh DD3344 Top Searches

These results are ranked by popularity.

Error
E-70Description: DF Gate error: The DF gate signal is not turned on for 10 seconds after the original has been transported from the original registration point. The DF gate signal is not turned off for 30 seconds after the machine has detected the ON signal
E-00Description: Clamper Motor Failure The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-22Description: 2nd Feed Start Timing Sensor error: The 2nd feed start timing sensor does not activate before the master eject position sensor activates.
E-71Description: DF Mismatch error: The machine detects that the installed ADF is not a correct option for this machine when the ADF is activated.
E-01Description: Cutter error: The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.

Ricoh DD3344 Common Errors

The most common error codes.

Error
E-70Description: DF Gate error: The DF gate signal is not turned on for 10 seconds after the original has been transported from the original registration point. The DF gate signal is not turned off for 30 seconds after the machine has detected the ON signal
E-00Description: Clamper Motor Failure The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-22Description: 2nd Feed Start Timing Sensor error: The 2nd feed start timing sensor does not activate before the master eject position sensor activates.
E-71Description: DF Mismatch error: The machine detects that the installed ADF is not a correct option for this machine when the ADF is activated.
E-01Description: Cutter error: The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.
E-70Description: DF Gate error: The DF gate signal is not turned on for 10 seconds after the original has been transported from the original registration point. The DF gate signal is not turned off for 30 seconds after the machine has detected the ON signal
E-00Description: Clamper Motor Failure The MPU cannot detect the clamper position sensor signal (open or closed) within 3.0 seconds after the clamper motor turns on.
E-22Description: 2nd Feed Start Timing Sensor error: The 2nd feed start timing sensor does not activate before the master eject position sensor activates.
E-71Description: DF Mismatch error: The machine detects that the installed ADF is not a correct option for this machine when the ADF is activated.
E-01Description: Cutter error: The cutter HP sensor does not turn on within 3.0 seconds after the cutter motor turns on.