OKI MPS5500mbf Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


OKI MPS5500mbf Top Searches

These results are ranked by popularity.

Error
922.81Description: Fuser warm-up failure Fuser type = 2 Fuser page count has exceeded life. The fuser hot roll did not reach operating temperature within new enhanced control.
31.05Description: Defective print cartridge or smart chip. Possible bad installation of smartchip or communication error with print cartridge ID connector assembly.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
954.xxDescription: NVRAM failure NVRAM chip failure with system card assembly.
925.26Description: Incorrect fuser or fuser lamp detected. Fuser type = 2 The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating.

OKI MPS5500mbf Common Errors

The most common error codes.

Error
922.81Description: Fuser warm-up failure Fuser type = 2 Fuser page count has exceeded life. The fuser hot roll did not reach operating temperature within new enhanced control.
31.05Description: Defective print cartridge or smart chip. Possible bad installation of smartchip or communication error with print cartridge ID connector assembly.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
954.xxDescription: NVRAM failure NVRAM chip failure with system card assembly.
925.26Description: Incorrect fuser or fuser lamp detected. Fuser type = 2 The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating.
922.81Description: Fuser warm-up failure Fuser type = 2 Fuser page count has exceeded life. The fuser hot roll did not reach operating temperature within new enhanced control.
31.05Description: Defective print cartridge or smart chip. Possible bad installation of smartchip or communication error with print cartridge ID connector assembly.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
954.xxDescription: NVRAM failure NVRAM chip failure with system card assembly.
925.26Description: Incorrect fuser or fuser lamp detected. Fuser type = 2 The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating.