OKI MB790 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


OKI MB790 Top Searches

These results are ranked by popularity.

Error
914.01Description: Pick arm motor overspeed failure. The pick arm motor does not rotate at the specified speed.
924.75Description: Open fuser thermistor check Fuser type = 2 Fuser page count has exceeded life. The fuser thermistor might be faulty.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
952.xxDescription: NVRAM failure A recoverable MVRAM Cyclic Redundancy Check (CRC) error occurred.
920.28Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool while checking for slope change in standby.

OKI MB790 Common Errors

The most common error codes.

Error
914.01Description: Pick arm motor overspeed failure. The pick arm motor does not rotate at the specified speed.
924.75Description: Open fuser thermistor check Fuser type = 2 Fuser page count has exceeded life. The fuser thermistor might be faulty.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
952.xxDescription: NVRAM failure A recoverable MVRAM Cyclic Redundancy Check (CRC) error occurred.
920.28Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool while checking for slope change in standby.
914.01Description: Pick arm motor overspeed failure. The pick arm motor does not rotate at the specified speed.
952.xxDescription: NVRAM failure A recoverable MVRAM Cyclic Redundancy Check (CRC) error occurred.
922.05Description: detection, did not roll over to steady state control in time. Fuser type = 1 The control code has gotten lost (this should really be a software error.
924.75Description: Open fuser thermistor check Fuser type = 2 Fuser page count has exceeded life. The fuser thermistor might be faulty.
920.28Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool while checking for slope change in standby.