These results are ranked by popularity.
Error | |
---|---|
842.xx | Description: ADF communication failure The ADF controller card has lost communication with the system. |
956.01 | Description: System card processor over temperature The system card processor is over temperature or is damaged. |
925.50 | Description: Incorrect fuser or fuser lamp detected. Fuser type = 1 Fuser page count has exceeded life. The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating. |
922.53 | Description: Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. The fuser hot roll does reach the “final lamp detection” parameter but not in the specified time. |
920.29 | Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool when heating to desired temperature after slope change within standby control only. |
The most common error codes.
Error | |
---|---|
842.xx | Description: ADF communication failure The ADF controller card has lost communication with the system. |
956.01 | Description: System card processor over temperature The system card processor is over temperature or is damaged. |
925.50 | Description: Incorrect fuser or fuser lamp detected. Fuser type = 1 Fuser page count has exceeded life. The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating. |
922.53 | Description: Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. The fuser hot roll does reach the “final lamp detection” parameter but not in the specified time. |
920.29 | Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool when heating to desired temperature after slope change within standby control only. |
842.xx | Description: ADF communication failure The ADF controller card has lost communication with the system. |
956.01 | Description: System card processor over temperature The system card processor is over temperature or is damaged. |
925.50 | Description: Incorrect fuser or fuser lamp detected. Fuser type = 1 Fuser page count has exceeded life. The machine detected a 115 V lamp in a 220 V machine. The fuser lamp has an excessive wattage rating. |
922.53 | Description: Fuser warm-up failure Fuser type = 1 Fuser page count has exceeded life. The fuser hot roll does reach the “final lamp detection” parameter but not in the specified time. |
920.29 | Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll is too cool when heating to desired temperature after slope change within standby control only. |