Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark XM7155 Top Searches

These results are ranked by popularity.

Error
952.xxDescription: A recoverable NVRAM Cyclic Redundancy Check (CRC) error occurred—n is the offset at which the error occurred.
34.xxDescription: Media size mismatch—the printer detects the media as too short or too narrow
140.10...146.00Description: 140.10 Main drive motor halls not detected 140.20 Main drive motor took too long to stop 140.30 Main drive motor unable To lock (before motor ID) 140.40 Main drive motor over speed detected 140.60 Main drive motor unable to lock (after motor
285.01Description: Media remains on the sensor (ADF media exit) during the warm-up sequence or at POR.
200.14Description: Proper main motor feedback to start laser servo was not received.

Lexmark XM7155 Common Errors

The most common error codes.

Error
952.xxDescription: A recoverable NVRAM Cyclic Redundancy Check (CRC) error occurred—n is the offset at which the error occurred.
34.xxDescription: Media size mismatch—the printer detects the media as too short or too narrow
140.10...146.00Description: 140.10 Main drive motor halls not detected 140.20 Main drive motor took too long to stop 140.30 Main drive motor unable To lock (before motor ID) 140.40 Main drive motor over speed detected 140.60 Main drive motor unable to lock (after motor
285.01Description: Media remains on the sensor (ADF media exit) during the warm-up sequence or at POR.
200.14Description: Proper main motor feedback to start laser servo was not received.
952.xxDescription: A recoverable NVRAM Cyclic Redundancy Check (CRC) error occurred—n is the offset at which the error occurred.
34.xxDescription: Media size mismatch—the printer detects the media as too short or too narrow
140.10...146.00Description: 140.10 Main drive motor halls not detected 140.20 Main drive motor took too long to stop 140.30 Main drive motor unable To lock (before motor ID) 140.40 Main drive motor over speed detected 140.60 Main drive motor unable to lock (after motor
285.01Description: Media remains on the sensor (ADF media exit) during the warm-up sequence or at POR.
200.14Description: Proper main motor feedback to start laser servo was not received.