Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark X651de Top Searches

These results are ranked by popularity.

Error
924.50Description: Open fuser thermistor check Fuser type = 1 Fuser page count has exceeded life. The fuser thermistor might be faulty.
927.05Description: Main cooling fan over speed failure. The main cooling fan does not reach the specified speed.
920.32Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll temperature is not maintained properly while the media in the fuser nip.
840.02Description: Scanner auto disabled The scanner has automatically been disabled by the controller
930.00 ... 933.00Description: 930.00 Incorrect printhead or intermittent Hsync A non supported printhead is installed. Hsync signal is intermittent or noisy. Printhead ID resistor circuit is not to spec. 931.00 No first laser H sync The hsync signal is missing or not at

Lexmark X651de Common Errors

The most common error codes.

Error
924.50Description: Open fuser thermistor check Fuser type = 1 Fuser page count has exceeded life. The fuser thermistor might be faulty.
927.05Description: Main cooling fan over speed failure. The main cooling fan does not reach the specified speed.
920.32Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll temperature is not maintained properly while the media in the fuser nip.
840.02Description: Scanner auto disabled The scanner has automatically been disabled by the controller
930.00 ... 933.00Description: 930.00 Incorrect printhead or intermittent Hsync A non supported printhead is installed. Hsync signal is intermittent or noisy. Printhead ID resistor circuit is not to spec. 931.00 No first laser H sync The hsync signal is missing or not at
924.50Description: Open fuser thermistor check Fuser type = 1 Fuser page count has exceeded life. The fuser thermistor might be faulty.
927.05Description: Main cooling fan over speed failure. The main cooling fan does not reach the specified speed.
920.32Description: Fuser warm-up failure Fuser type = 2 The fuser hot roll temperature is not maintained properly while the media in the fuser nip.
840.02Description: Scanner auto disabled The scanner has automatically been disabled by the controller
930.00 ... 933.00Description: 930.00 Incorrect printhead or intermittent Hsync A non supported printhead is installed. Hsync signal is intermittent or noisy. Printhead ID resistor circuit is not to spec. 931.00 No first laser H sync The hsync signal is missing or not at