Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark X364dw Top Searches

These results are ranked by popularity.

Error
37Description: Insufficient Collation Area
200.33Description: Page from tray 1 did not reach the input sensor after multiple attempts. Page did make it out of the tray at least as far as the manual feeder sensor. Possible cause is that the page stalled at the alignment gate.
902.xx...906.xxDescription: 902.xx Engine software error 903.xx Paperport link driver error 904.xx Interface violation by RIP 905.xx Interface violation by paperport device 906.xx RIP interface drive error
200.04Description: The media at the input sensor before interrupt occurred–not enough time elapsed since the printhead started to expect the printhead mirror motor lock. Possible causes include bouncy sensor or exceptionally fast pick– perhaps due to media pre
951.xxDescription: Error with secure NVRAM on the controller board

Lexmark X364dw Common Errors

The most common error codes.

Error
37Description: Insufficient Collation Area
200.33Description: Page from tray 1 did not reach the input sensor after multiple attempts. Page did make it out of the tray at least as far as the manual feeder sensor. Possible cause is that the page stalled at the alignment gate.
902.xx...906.xxDescription: 902.xx Engine software error 903.xx Paperport link driver error 904.xx Interface violation by RIP 905.xx Interface violation by paperport device 906.xx RIP interface drive error
200.04Description: The media at the input sensor before interrupt occurred–not enough time elapsed since the printhead started to expect the printhead mirror motor lock. Possible causes include bouncy sensor or exceptionally fast pick– perhaps due to media pre
951.xxDescription: Error with secure NVRAM on the controller board
37Description: Insufficient Collation Area
200.33Description: Page from tray 1 did not reach the input sensor after multiple attempts. Page did make it out of the tray at least as far as the manual feeder sensor. Possible cause is that the page stalled at the alignment gate.
902.xx...906.xxDescription: 902.xx Engine software error 903.xx Paperport link driver error 904.xx Interface violation by RIP 905.xx Interface violation by paperport device 906.xx RIP interface drive error
200.04Description: The media at the input sensor before interrupt occurred–not enough time elapsed since the printhead started to expect the printhead mirror motor lock. Possible causes include bouncy sensor or exceptionally fast pick– perhaps due to media pre
951.xxDescription: Error with secure NVRAM on the controller board