Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark MX610 Top Searches

These results are ranked by popularity.

Error
841.xxDescription: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
954.xxDescription: Service NVRAM Failure The NVRAM chip failure with controller part.
978.xxDescription: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port.

Lexmark MX610 Common Errors

The most common error codes.

Error
841.xxDescription: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
954.xxDescription: Service NVRAM Failure The NVRAM chip failure with controller part.
978.xxDescription: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port.
841.xxDescription: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
954.xxDescription: Service NVRAM Failure The NVRAM chip failure with controller part.
978.xxDescription: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port.