These results are ranked by popularity.
Error | |
---|---|
155.00 | Description: No encoder received from auger motor. |
841.xx | Description: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found |
202.01...202.28 | Description: 202.01 Exit sensor is covered during warm up. 202.03 Media did not reach the fuser exit sensor. 202.05 Fuser exit sensor covered too long by the current sheet. 202.07 Fuser exit sensor covered too long by the previous sheet. 202.13 Restart a |
954.xx | Description: Service NVRAM Failure The NVRAM chip failure with controller part. |
983.xx | Description: Invalid command received by the specified device |
The most common error codes.
Error | |
---|---|
155.00 | Description: No encoder received from auger motor. |
841.xx | Description: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found |
202.01...202.28 | Description: 202.01 Exit sensor is covered during warm up. 202.03 Media did not reach the fuser exit sensor. 202.05 Fuser exit sensor covered too long by the current sheet. 202.07 Fuser exit sensor covered too long by the previous sheet. 202.13 Restart a |
954.xx | Description: Service NVRAM Failure The NVRAM chip failure with controller part. |
983.xx | Description: Invalid command received by the specified device |
155.00 | Description: No encoder received from auger motor. |
841.xx | Description: Scanner failure—front side image processing ASIC. Invalid configuration or ASIC not found |
202.01...202.28 | Description: 202.01 Exit sensor is covered during warm up. 202.03 Media did not reach the fuser exit sensor. 202.05 Fuser exit sensor covered too long by the current sheet. 202.07 Fuser exit sensor covered too long by the previous sheet. 202.13 Restart a |
954.xx | Description: Service NVRAM Failure The NVRAM chip failure with controller part. |
983.xx | Description: Invalid command received by the specified device |