Lexmark MS810n Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark MS810n Top Searches

These results are ranked by popularity.

Error
202.45Description: Media remains on the sensor (fuser exit) during the warm.up sequence
200.15Description: Media reached the sensor (input) but did not clear it within the specified time. (Media source = Tray 1)
959.01, 959.02, 959.03Description: 959.01 Controller verification failure of smart chip boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition
59Description: Incompatible output bin/tray
121.07...121.24Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold 121.08 Fuser was under temperature when page was in fuser 121.20 Fuser undertemp during steady state control 121.22 Fuser did not warm

Lexmark MS810n Common Errors

The most common error codes.

Error
202.45Description: Media remains on the sensor (fuser exit) during the warm.up sequence
200.15Description: Media reached the sensor (input) but did not clear it within the specified time. (Media source = Tray 1)
959.01, 959.02, 959.03Description: 959.01 Controller verification failure of smart chip boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition
59Description: Incompatible output bin/tray
121.07...121.24Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold 121.08 Fuser was under temperature when page was in fuser 121.20 Fuser undertemp during steady state control 121.22 Fuser did not warm
202.45Description: Media remains on the sensor (fuser exit) during the warm.up sequence
200.15Description: Media reached the sensor (input) but did not clear it within the specified time. (Media source = Tray 1)
959.01, 959.02, 959.03Description: 959.01 Controller verification failure of smart chip boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition
59Description: Incompatible output bin/tray
121.07...121.24Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold 121.08 Fuser was under temperature when page was in fuser 121.20 Fuser undertemp during steady state control 121.22 Fuser did not warm