Lexmark MS810 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark MS810 Top Searches

These results are ranked by popularity.

Error
202.01Description: Media remains on the sensor (narrow media) during the warm.up sequence
949.xxDescription: Failed engine card—delay line calibration failure.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet time-out 31.62 Imaging unit I2C packet has been sent, but code timed-out on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.6
133.05...133.08Description: 133.05 Toner Level Sensing reading above maximum expected value 133.06 Toner Level Sensing reading below minimum expected value 133.07 Toner failed to replenish into the Imaging Unit 133.08 Excessive toner level sensing noise
52Description: Flash full

Lexmark MS810 Common Errors

The most common error codes.

Error
202.01Description: Media remains on the sensor (narrow media) during the warm.up sequence
949.xxDescription: Failed engine card—delay line calibration failure.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet time-out 31.62 Imaging unit I2C packet has been sent, but code timed-out on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.6
133.05...133.08Description: 133.05 Toner Level Sensing reading above maximum expected value 133.06 Toner Level Sensing reading below minimum expected value 133.07 Toner failed to replenish into the Imaging Unit 133.08 Excessive toner level sensing noise
52Description: Flash full
202.01Description: Media remains on the sensor (narrow media) during the warm.up sequence
949.xxDescription: Failed engine card—delay line calibration failure.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet time-out 31.62 Imaging unit I2C packet has been sent, but code timed-out on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.6
133.05...133.08Description: 133.05 Toner Level Sensing reading above maximum expected value 133.06 Toner Level Sensing reading below minimum expected value 133.07 Toner failed to replenish into the Imaging Unit 133.08 Excessive toner level sensing noise
52Description: Flash full