Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark MS610dtn Top Searches

These results are ranked by popularity.

Error
325.60...325.63Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board.
121.07...121.37Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand
959.xxDescription: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow
200.16Description: Fuser motor stalled.
983.xxDescription: Invalid command received by the specified device

Lexmark MS610dtn Common Errors

The most common error codes.

Error
325.60...325.63Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board.
121.07...121.37Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand
959.xxDescription: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow
200.16Description: Fuser motor stalled.
983.xxDescription: Invalid command received by the specified device
325.60...325.63Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board.
121.07...121.37Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand
959.xxDescription: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow
200.16Description: Fuser motor stalled.
983.xxDescription: Invalid command received by the specified device