Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Lexmark MS610de Top Searches

These results are ranked by popularity.

Error
961.xxDescription: Service Memory Failure RAM memory error: slot 1 RAM is bad.
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
80Description: Maintenance kit
950.xxDescription: NVRAM mismatch failure—mismatch between controller board EEPROM and control panel mirror. ".xx" codes: • 00-29— mismatch between system and mirror • 30-60—mismatch between secure and system

Lexmark MS610de Common Errors

The most common error codes.

Error
961.xxDescription: Service Memory Failure RAM memory error: slot 1 RAM is bad.
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
80Description: Maintenance kit
950.xxDescription: NVRAM mismatch failure—mismatch between controller board EEPROM and control panel mirror. ".xx" codes: • 00-29— mismatch between system and mirror • 30-60—mismatch between secure and system
961.xxDescription: Service Memory Failure RAM memory error: slot 1 RAM is bad.
200.31, 200.32, 200.33Description: 200.31 Paper, in the middle of a job, at input sensor before interrupt occurred. 200.32 Detected cover switch bounce. 200.33 Input sensor covered too quickly.
31.60...31.65Description: 31.60 Imaging unit smart chip error 31.61 Imaging unit I2C packet timeout 31.62 Imaging unit I2C packet has been sent but code timedout on receiving the data (callback) 31.63 Imaging unit security error in the send challenge sequence 31.64 I
80Description: Maintenance kit
950.xxDescription: NVRAM mismatch failure—mismatch between controller board EEPROM and control panel mirror. ".xx" codes: • 00-29— mismatch between system and mirror • 30-60—mismatch between secure and system