These results are ranked by popularity.
Error | |
---|---|
961.xx | Description: Service Memory Failure RAM memory error: slot 1 RAM is bad. |
332.54, 332.55, 332.56 | Description: 332.54 Motor 2 (Separator/Passthru) Motor no first encoder 332.55 Motor 2 (Separator/Passthru) motor stop error 332.56 Motor 2 (Separator/Passthru) PWM underflow (motor overspeed) |
132.01...132.34 | Description: 132.01 TDS baseline too low. 132.02 TDS baseline too high. 132.03 TDS baseline excessive range. 132.16 TDS calibration at maximum. 132.17 TDS calibration too low. 132.18 TDS calibration too close to baseline. 132.32 PC drum measurement too h |
80 | Description: Maintenance kit |
200.23, 200.24, 200.29, 200.30 | Description: 200.23 Laser servo never started due to potential conflict with the transfer servo. 200.24 Measured gap at input sensor too small to meet video delivery requirements. (Not enough time since prior image finished to start new image). 200.29 Pr |
The most common error codes.
Error | |
---|---|
961.xx | Description: Service Memory Failure RAM memory error: slot 1 RAM is bad. |
332.54, 332.55, 332.56 | Description: 332.54 Motor 2 (Separator/Passthru) Motor no first encoder 332.55 Motor 2 (Separator/Passthru) motor stop error 332.56 Motor 2 (Separator/Passthru) PWM underflow (motor overspeed) |
132.01...132.34 | Description: 132.01 TDS baseline too low. 132.02 TDS baseline too high. 132.03 TDS baseline excessive range. 132.16 TDS calibration at maximum. 132.17 TDS calibration too low. 132.18 TDS calibration too close to baseline. 132.32 PC drum measurement too h |
80 | Description: Maintenance kit |
200.23, 200.24, 200.29, 200.30 | Description: 200.23 Laser servo never started due to potential conflict with the transfer servo. 200.24 Measured gap at input sensor too small to meet video delivery requirements. (Not enough time since prior image finished to start new image). 200.29 Pr |
961.xx | Description: Service Memory Failure RAM memory error: slot 1 RAM is bad. |
332.54, 332.55, 332.56 | Description: 332.54 Motor 2 (Separator/Passthru) Motor no first encoder 332.55 Motor 2 (Separator/Passthru) motor stop error 332.56 Motor 2 (Separator/Passthru) PWM underflow (motor overspeed) |
132.01...132.34 | Description: 132.01 TDS baseline too low. 132.02 TDS baseline too high. 132.03 TDS baseline excessive range. 132.16 TDS calibration at maximum. 132.17 TDS calibration too low. 132.18 TDS calibration too close to baseline. 132.32 PC drum measurement too h |
80 | Description: Maintenance kit |
200.23, 200.24, 200.29, 200.30 | Description: 200.23 Laser servo never started due to potential conflict with the transfer servo. 200.24 Measured gap at input sensor too small to meet video delivery requirements. (Not enough time since prior image finished to start new image). 200.29 Pr |