These results are ranked by popularity.
Error | |
---|---|
325.60...325.63 | Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board. |
121.07...121.37 | Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand |
959.xx | Description: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow |
983.xx | Description: Invalid command received by the specified device |
52 | Description: Flash full |
The most common error codes.
Error | |
---|---|
325.60...325.63 | Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board. |
121.07...121.37 | Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand |
959.xx | Description: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow |
983.xx | Description: Invalid command received by the specified device |
52 | Description: Flash full |
325.60...325.63 | Description: 325.60 Hardware error—Board ID unknown 325.61 Hardware error—Option type unknown 325.62 Hardware error—Product ID unknown 325.63 Hardware error—Sensors are not plugged on the board. |
121.07...121.37 | Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. 121.08 Fuser was under temp when page was in fuser. 121.20 Fuser undertemp during steady state control. Can ocurr in printing or stand |
959.xx | Description: 959.01 Controller verification failure of pensive boot code 959.02 Failure to authenticate Signature Verification Code 959.03 Signature Verification Code failed to authenticate a code partition 959.04 Jump to unverified address 959.05 Unknow |
983.xx | Description: Invalid command received by the specified device |
52 | Description: Flash full |