These results are ranked by popularity.
Error | |
---|---|
978.xx | Description: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port. |
121.01...121.42 | Description: 121.01 Service Fuser Error Attempting to print with estimated power at or below minimum power. 121.02 Service Fuser Error Fuser is over temperature. 121.03 Service Fuser Error Fuser open thermistor check failed. 121.04 Service Fuser Error At |
846.00...846.07 | Description: 846.00 Calibration Strip Unusable Scanner failure: Calibration strip 846.01 Rear Calibration Strip Unusable 846.02 Front calibration strip too far left 846.03 Front calibration strip too far right 846.04 Front calibration strip has excessive |
956.xx | Description: Service Controller Board Controller board failure. Processor failure. Check on .02 for fan error. |
979.xx | Description: 979.xx Service Standard Network or 979.xx Service Network Card x Flash parts failed while programming the Standard Network or Network Card x port. |
The most common error codes.
Error | |
---|---|
978.xx | Description: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port. |
121.01...121.42 | Description: 121.01 Service Fuser Error Attempting to print with estimated power at or below minimum power. 121.02 Service Fuser Error Fuser is over temperature. 121.03 Service Fuser Error Fuser open thermistor check failed. 121.04 Service Fuser Error At |
846.00...846.07 | Description: 846.00 Calibration Strip Unusable Scanner failure: Calibration strip 846.01 Rear Calibration Strip Unusable 846.02 Front calibration strip too far left 846.03 Front calibration strip too far right 846.04 Front calibration strip has excessive |
956.xx | Description: Service Controller Board Controller board failure. Processor failure. Check on .02 for fan error. |
979.xx | Description: 979.xx Service Standard Network or 979.xx Service Network Card x Flash parts failed while programming the Standard Network or Network Card x port. |
978.xx | Description: 978.xx Service Standard Network or 978.xx Service Network Card x Bad checksum while programming Standard Network or Network Card x port. |
121.01...121.42 | Description: 121.01 Service Fuser Error Attempting to print with estimated power at or below minimum power. 121.02 Service Fuser Error Fuser is over temperature. 121.03 Service Fuser Error Fuser open thermistor check failed. 121.04 Service Fuser Error At |
846.00...846.07 | Description: 846.00 Calibration Strip Unusable Scanner failure: Calibration strip 846.01 Rear Calibration Strip Unusable 846.02 Front calibration strip too far left 846.03 Front calibration strip too far right 846.04 Front calibration strip has excessive |
956.xx | Description: Service Controller Board Controller board failure. Processor failure. Check on .02 for fan error. |
979.xx | Description: 979.xx Service Standard Network or 979.xx Service Network Card x Flash parts failed while programming the Standard Network or Network Card x port. |