Error |
---|
These results are ranked by popularity.
Error | |
---|---|
6610 | Description: The fuser pressure release error The fuser release sensor does not turn on or off, after 30 s from starting pressurization or depressurization operation. |
2202 | Description: Drum motor KM steadystate error After motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
7913 | Description: Developer unit M EEPROM error (1)No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated 5 times successively. (2)Mismatch of reading data from two locations occurs 8 times successively. (3)Mism |
4012 | Description: Polygon motor (Cyan, Yellow) steady error After the polygon motor stabilization, the motor stable signal is turned OFF for consecutive 6 s. |
0190 | Description: Backup memory device error (Main/Engine PWB) At power up, read/write data from FRAM can not be performed. (retry: 3times) |
The most common error codes.
Error | |
---|---|
6610 | Description: The fuser pressure release error The fuser release sensor does not turn on or off, after 30 s from starting pressurization or depressurization operation. |
2202 | Description: Drum motor KM steadystate error After motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
7913 | Description: Developer unit M EEPROM error (1)No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated 5 times successively. (2)Mismatch of reading data from two locations occurs 8 times successively. (3)Mism |
4012 | Description: Polygon motor (Cyan, Yellow) steady error After the polygon motor stabilization, the motor stable signal is turned OFF for consecutive 6 s. |
0190 | Description: Backup memory device error (Main/Engine PWB) At power up, read/write data from FRAM can not be performed. (retry: 3times) |
7913 | Description: Developer unit M EEPROM error (1)No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated 5 times successively. (2)Mismatch of reading data from two locations occurs 8 times successively. (3)Mism |
2202 | Description: Drum motor KM steadystate error After motor is stabilized, the stable signal is turned OFF for continuous 2 s. |
6610 | Description: The fuser pressure release error The fuser release sensor does not turn on or off, after 30 s from starting pressurization or depressurization operation. |
7402 | Description: Developer unit C type mismatch error (Cyan) Improper adaptation of the main unit and developer unit is detected. |
0190 | Description: Backup memory device error (Main/Engine PWB) At power up, read/write data from FRAM can not be performed. (retry: 3times) |