Kyocera KM6330 Error Codes


Select an Error Code or Type an Error Code to begin searching

Error


Have a better picture? Update the product image. PNG Only. Open a new private window or clear your cache to see the new image.


Kyocera KM6330 Top Searches

These results are ranked by popularity.

Error
C5610Description: Drum surface potential problem 2 • Minimizing the grid output cannot set the potential.
C8030Description: Upper paper conveying belt problem • During initialization, the intermediate tray upper sliding plate is not detected in the home position within 3 s after the belt returns to the home position. JAM87 is indicated the first time this problem
C1030Description: Upper lift motor problem • When the upper cassette is inserted, the upper lift limit switch does not turn on within 9 s of the upper lift motor turning on. • During copying, the upper lift limit switch does not turn on within 200 ms of the u
C3300Description: Optical system (AGC) problem • After AGC, correct input is not obtained at CCD.
C6400Description: Zero-crossing signal problem • The main PCB does not detect the zero-crossing signal (Z CROSS SIG) for the time specified below. At power-on: 3 s Others: 5 s

Kyocera KM6330 Common Errors

The most common error codes.

Error
C5610Description: Drum surface potential problem 2 • Minimizing the grid output cannot set the potential.
C8030Description: Upper paper conveying belt problem • During initialization, the intermediate tray upper sliding plate is not detected in the home position within 3 s after the belt returns to the home position. JAM87 is indicated the first time this problem
C1030Description: Upper lift motor problem • When the upper cassette is inserted, the upper lift limit switch does not turn on within 9 s of the upper lift motor turning on. • During copying, the upper lift limit switch does not turn on within 200 ms of the u
C3300Description: Optical system (AGC) problem • After AGC, correct input is not obtained at CCD.
C6400Description: Zero-crossing signal problem • The main PCB does not detect the zero-crossing signal (Z CROSS SIG) for the time specified below. At power-on: 3 s Others: 5 s
C5610Description: Drum surface potential problem 2 • Minimizing the grid output cannot set the potential.
C8030Description: Upper paper conveying belt problem • During initialization, the intermediate tray upper sliding plate is not detected in the home position within 3 s after the belt returns to the home position. JAM87 is indicated the first time this problem
C1030Description: Upper lift motor problem • When the upper cassette is inserted, the upper lift limit switch does not turn on within 9 s of the upper lift motor turning on. • During copying, the upper lift limit switch does not turn on within 200 ms of the u
C3300Description: Optical system (AGC) problem • After AGC, correct input is not obtained at CCD.
C6400Description: Zero-crossing signal problem • The main PCB does not detect the zero-crossing signal (Z CROSS SIG) for the time specified below. At power-on: 3 s Others: 5 s